SUBJECT: Refrigeration Issues Caused By Control Board Battery Replacement REVISION: 00 MODELS: All Venders with Electronic Refrigeration PURPOSE: Replacing a control board battery could affect the calibration of the vender’s temperature sensor, causing evaporator freeze-ups or warm product. This bulletin explains the corrective procedure for this issue. Download PDF: Service Bulletin 267 … [Read more...]
18. Ground Strap for the Inner Door
June 18, 2002 by ·
Subject: Ground Strap for the Inner Door Revision: 03 Models: All Venders Tools required: Phillips screwdriver, drill, 1/8” drill bit Estimated time: 1 minute Purpose: For instructions on installing a ground strap to the inner door. Download PDF: Helpful Hint 18 … [Read more...]
6. Preventive Maintenance for Ballast Assembly
June 18, 2002 by ·
Subject: Preventive Maintenance for Ballast Assembly Revision: 03 Models: All Venders with Ballast Assembly Tools required: None Estimated time: 10 minutes Purpose: To obtain maximum efficiency of the ballast. Download PDF: Helpful Hint 6 … [Read more...]
5. Leveling leg adjustment to encourage water drainage to the rear of vender
August 13, 2001 by ·
Subject: Leveling leg adjustment to encourage water drainage to the rear of vender Revision: 01 Models: All venders Tools required: Adjustable wrench Estimated time: 3 minutes Purpose: To promote water drainage to the rear of the vender, instead of towards the door seal. Download PDF: Helpful Hint 5 … [Read more...]
