Product name: 240 ml / 250 mL Can Bottler / company: Volume: 240 ml / 250 mL Package type: Can Height: 5.22 in. / 13.3 cm Diameter: 2.08 in. / 5.3 cm Weight: 0.58 lb. / 0.26 kg Country of origin: USA Venders: GIII, MIV, EZ, Electro-Mechanical, Merlin 2000, Merlin III, RB Download PDF: PVS 13 … [Read more...]
205. Coin Box Housing Kit Installation
SUBJECT: Coin Box Housing Kit Installation REVISION: 03 MODELS: Non CDC Venders, RVCC(E), RVMC(E), RVCD(E) PURPOSE: To prevent vandals from punching out the coin cup and taking the coins from the coin box. Download PDF: Service Bulletin 205 … [Read more...]
109. Installation of Heater Kit
SUBJECT: Installation of Heater Kit REVISION: 10 MODELS: Merlin III, GII VII, GIII, Merlin IV, TDV, HVV PURPOSE: The heater pad kit is designed to prevent products from freezing inside the vender in cold climates. This bulletin describes the proper procedure for installing the kit. Download PDF: Service Bulletin 109 … [Read more...]
329. Piezoresistive Chute Sensor Installation
SUBJECT: Piezoresistive Chute Sensor Installation REVISION: 00 MODELS: All conventional venders PURPOSE: Beginning with vender serial number 201030BA00001, the older-style chute sensor has been replaced by a piezoresistive sensor. This bulletin explains the procedure for installing the newer sensor in place of the original-style sensor. Download PDF: Service Bulletin 329 … [Read more...]
267. Refrigeration Issues Caused By Control Board Battery Replacement
SUBJECT: Refrigeration Issues Caused By Control Board Battery Replacement REVISION: 00 MODELS: All Venders with Electronic Refrigeration PURPOSE: Replacing a control board battery could affect the calibration of the vender’s temperature sensor, causing evaporator freeze-ups or warm product. This bulletin explains the corrective procedure for this issue. Download PDF: Service Bulletin 267 … [Read more...]
6. Preventive Maintenance for Ballast Assembly
Subject: Preventive Maintenance for Ballast Assembly Revision: 03 Models: All Venders with Ballast Assembly Tools required: None Estimated time: 10 minutes Purpose: To obtain maximum efficiency of the ballast. Download PDF: Helpful Hint 6 … [Read more...]
5. Leveling leg adjustment to encourage water drainage to the rear of vender
Subject: Leveling leg adjustment to encourage water drainage to the rear of vender Revision: 01 Models: All venders Tools required: Adjustable wrench Estimated time: 3 minutes Purpose: To promote water drainage to the rear of the vender, instead of towards the door seal. Download PDF: Helpful Hint 5 … [Read more...]
